Cambium Networks 5GHz 450b High Gain Radio (FCC)
Capable of up to 300Mbps aggregate in a 40MHz channel
SKU
C050045B022A
Weight
1.05 lb
Stock Quantity
Call for availability
Cambium Networks 450 platform increases performance with the addition of the 5GHz 450b Subscriber and Backhaul Module.
Capable of up to 300Mbps aggregate in a 40MHz channel with an ultra-wide band radio functioning in the 4.9GHz to 5.9GHz frequency range. It can function as a Point-to-Point (PTP) link or as a Subscriber Module (SM).
Product Features- Gigabit Ethernet Interface provides the maximum transfer rates to the device
- 3.5 mm audio jack allows direct connection of headphones for alignment without any adapters
- New System on a Chip (SoC) enhances Packet Processing Power more than 4x that of the 450 SM
- Integrated antenna 24dBi peak gain
- Channel Width: 5MHz, 10MHz, 15MHz, 20MHz, 30MHz or 40MHz
- 2x2 MIMO OFDM Physical Layer
- Radio Only
- 4-Pack high gain antenna assembly: N050045D002A
- Power Supply
- Optional Radome: N000900L021A
| Spectrum | |
| Channel Spacing | Configurable on 2.5MHz increments |
| Frequency Range | 4900MHz - 5925MHz |
| Channel Width | 5MHz, 10MHz, 15MHz, 20MHz, 30MHz or 40MHz |
| Interface | |
| MAC (Media Access Control) Layer | Cambium Networks proprietary |
| Physical Layer | 2x2 MIMO OFDM |
| Ethernet Interface | 100/1000 BaseT, full duplex, rate auto negotiated, 802.3 compliant |
| Protocols Used | IPv4, IPv6, UDP, TCP/IP, ICMP, Telnet, SNMP, HTTP, FTP |
| Network Management | IPv4/IPv6 (dual stack), HTTP, HTTPS, Telnet, FTP, SNMPv2c and v3, Cambium Networks cnMaestro |
| Wi-Fi | 802.11 a/b/g/n/ac Wave 2 |
| MTU | 1700 bytes |
| VLAN | 802.1ad (DVLAN Q-inQ), 802.1Q with 802.1p priority, dynamic port VID |
| Security | |
| Encryption | FIPS-197 128-bit AES, 256-bit AES (Requires Optional License for attached Access Point) |
| Performance | |
| PPS | 50,000 |
| ARQ | Yes |
| Ultimate Sensitivity | −94dBm |
| Maximum Deployment Range | Up to 64km (40 miles) in PMP mode, up to 200km (124 miles) in PTP mode |
| Latency | 3ms - 5ms, typical |
| GPS Synchronization | Yes, synchronized by Access Point or via 3.5mm port using cnPulse (for PTP mode) |
| Quality of Service | Diffserve QoS |
| Antenna | |
| Integrated Antenna Peak Gain | 24dBi |
| 3 dB Beamwidth - Azimuth | 7° |
| 3 dB Beamwidth - Elevation | 7° |
| Polarization | Dual linear, H + V |
| Front-To-Back Isolation | 390g (0.86lb) |
| Security | > 25dB |
| Cross Polarization | 15dB |
| Physical | |
| Antenna Accessories | Optional Radome: N000900L021A |
| Surge Suppression | EN 61000-4-5: 10x700 ?s, 4 kV, EN 61000-4-2: ESD 30 kV contact / 30 kV air |
| Mean Time Between Failure | > 40 Years |
| Environmental | IP55, Optional glands to enhance to IP67 (Part number N000000L135A) |
| Wind Survival | 200 kph (124 mph) |
| Temperature / Humidity | −40°C to 60°C (−40°F to 140°F), 0–100% non-condensing |
| Weight | 3.1kg (7lbs) including mounting bracket |
| Dimensions (HxWxD) | Diameter 45cm x 28cm (17.8in x 11.2in) |
| Pole Diameter Range (w/ included mount) | 2.5cm to 7.6cm (1in to 3in) ±20 degrees mechanical tilt |
| Power Consumption | 9W typical, 12W peak |
| Input Voltage | 20–32 VDC |
| Link Budget | |
| Transmit Power Range | 54dB dynamic range (to EIRP limit by region) (1dB step) |
| Maximum Transmit Power | +27dBm (MIMO, combined V+H) |
| Transmit Power Range | dynamic54dB range (to EIRP limit by region) (1dB step) |
| Power Control | ATPC (Automatic Transmit Power Control) at system level, all Subscribers implement ATPC |
| Certifications | |
| ISED Canada | 109W-0042 |
| FCC ID | Z8H89FT0042 |
| ETSI | EN 301 893 v2.1.1, EN 302 502 v2.1.1 |
Related Products
SKU DPR-F140
SKU KPPA-J-ARM
Call for availability
SKU KPPA-J-ARM-24-2P
Call for availability
SKU KPPA-J-ARM-39-4P
SKU N050045D002A
SKU CYG-CPCNAC5-3FT
